What “compost Kc” actually refers to

Kc is the crop coefficient — a dimensionless multiplier that turns reference evapotranspiration (ETo) into crop water use, ETc = Kc × ETo. Compost does not have a Kc of its own, and you will not find a compost row in the FAO-56 tables. What compost changes sits on the soil side of the equation: the evaporation component (Ke), how much water the root zone can hold, and indirectly the canopy size that drives basal transpiration (Kcb). So the compost Kc you schedule with is a locally adjusted number, not a lookup value — and the adjustment is usually smaller than suppliers imply.

Tractor boom sprayer applying foliar fertilizer over green crop rows

The dual-coefficient form is the one worth carrying into the field: ETc = (Kcb + Ke) × ETo. Kcb describes the crop, Ke describes the wet soil surface. Compost mulch attacks Ke directly by shrinking the fraction of soil that is both wetted and exposed. Incorporated compost works more slowly, through the water-balance term.

Three things that actually matter

1. Mulch versus incorporated — two different mechanisms

A surface layer of compost is a mulch. It reduces the exposed, wetted fraction of the soil surface, which is the physical driver of Ke in the FAO-56 framework, and it keeps the top 5 cm cooler and damper. Expect the biggest effect in the first week after irrigation or rain, when bare soil would otherwise be evaporating at close to its maximum rate. Incorporated compost does something else: it raises organic matter, improves aggregate stability and increases plant-available water, so the same irrigation lasts longer between events. It barely touches Ke once the surface has been mixed and re-settled.

2. Maturity, salinity and hydrophobicity

Immature compost is a scheduling hazard. If it is still actively decomposing, it can immobilise nitrogen, thin the canopy and leave you with a crop that transpires less than the table value — while the same material’s high salts pull water away from the root zone. Dry compost mulch can also become hydrophobic, shedding irrigation water rather than absorbing it. Check electrical conductivity (EC) before you build a schedule around a new batch; values in the 1–10 dS/m range are common for manure-based composts, and the higher end needs a leaching fraction and a re-think of your Kc assumption. The fertilizer and nutrient management reference covers the nitrogen side of this in more detail.

3. The Kc tables assume a field, not your bed

Published coefficients assume large, uniform, well-watered, disease-free fields with a defined fetch and climate. A 30 m market garden bed next to a windbreak, a high-altitude site or an arid advection zone will drift from those numbers regardless of what you spread on top. Compost is one more reason to treat tabulated Kc as a starting point and refine it locally — which is exactly what the test in the last section does.

Numbers worth knowing

Ballpark mid-season Kcb values from FAO-56 are worth keeping in your head: maize around 1.15, wheat 1.10, tomato 1.10, potato 1.10, lettuce 1.00. Bare, freshly wetted soil can push Ke toward Kcmax, typically 1.05–1.30 depending on wind, humidity and crop height. Those are the numbers compost is competing against.

Situation Typical effect on the coefficient Practical note
Bare, freshly irrigated soil (no compost) Ke approaching Kcmax, roughly 1.05–1.30 Falls off over 2–4 days as the surface dries
2–3 cm compost mulch Effective Ke roughly halved in the first week after wetting Effect fades as the mulch crusts and mixes
5 cm or deeper compost mulch Ke reduced by roughly 50–70% while the layer stays intact Re-top annually; watch for hydrophobic crusting
Incorporated compost, 10–30 t/ha Kcb largely unchanged; plant-available water up Rule of thumb: 1–3 mm extra available water per 100 mm of soil depth per 1% organic matter gained (estimate; varies with texture)
Immature or high-EC compost Kcb often below the table value Smaller canopy, slower establishment; do not schedule as if the crop were full-size

Two physical figures are useful for dosing. Mature compost holds roughly 100–200% of its dry weight in water and sits at a bulk density of about 400–600 kg/m³, so 1 cm spread over one hectare is in the order of 40–60 tonnes of material. That is why a 5 cm mulch layer is a serious input cost and why most growers incorporate 10–30 t/ha instead. If you are comparing compost with other water-holding amendments, the super absorbent polymer application notes give a like-for-like frame.

When the usual advice is wrong

“Add compost, cut irrigation by 30%.” Compost raises stored water, but it also tends to grow a bigger, healthier canopy — which raises transpiration. In humid climates the evaporation saving is small, so the net change in ETc can be close to zero. In arid, windy conditions the saving is real but concentrated in the days right after each irrigation.

“Use Kc 0.6 for compost.” Any single number attached to compost is a category error. Kc belongs to a crop and a growth stage; the compost belongs to the soil and surface treatment. What you can defend is an adjusted Ke, or an adjusted irrigation interval at unchanged Kc.

Treating the first season like the fifth. Freshly amended soil behaves differently from long-term amended soil. Organic matter takes two to three seasons to move the water-holding curve meaningfully, while the mulch effect on Ke is immediate and then decays. Scheduling for the mature state in year one tends to under-irrigate.

Ignoring depth. Compost changes the top 20–30 cm far more than the profile below. If your Kc-based schedule assumes a 60 cm root zone, the amendment is influencing only part of it — and a sensor at 40 cm will tell you almost nothing about whether the compost is working. The irrigation and soil water management hub goes deeper on placement and probe siting.

A quick way to test it yourself

You do not need a lysimeter. A moisture probe, a scale and an oven will do, and a paired-plot run over 8–10 days gives you a number you can actually schedule with.

    • Pick two adjacent beds or plots with the same soil, crop, planting date and irrigation system. One gets compost, one does not.
    • Install sensors or take cores at 10 cm and 30 cm in both. Note the depth of the compost layer and whether it is incorporated.
    • Irrigate both plots to the same depth — 20–25 mm is a workable target — early in the morning so the day’s evaporation curve is comparable.
    • Sample 24 hours later, then every second day for 8–10 days, at the same hour each time.
    • Convert volumetric water content to millimetres: Δθ × root-zone depth in mm. A 0.02 change over 300 mm is 6 mm of water.
    • Divide daily depletion by that day’s ETo from a nearby weather station or on-farm gauge.
    • The ratio is your local Kc for each plot. The gap between the two plots is the compost effect, expressed in the same units you schedule in.
    • Repeat once mid-season. A single run is noise; two runs on the same ground start to be a pattern.

For a near-zero-cost version, take a 20 cm core, weigh it wet, dry it at 105 °C for 24 hours, weigh again, and calculate gravimetric water content before converting with bulk density. Slower, but it needs no electronics and no calibration.

Questions that come up

Does compost have a Kc value of its own?

No. Kc describes a crop’s water use relative to a reference surface. Compost changes soil evaporation and storage, so it modifies the Ke term and the water balance rather than contributing a coefficient. Any “compost Kc” figure you are quoted should be treated as shorthand for a local adjustment.

Is “compost Kc” the same as potassium?

Usually not, but the confusion is common. In fertility work, K is potassium and Kc is sometimes used loosely for potassium content. If that is what you need: mature compost typically supplies roughly 0.5–1.5% K₂O on a dry-weight basis, with much of it available in the first season. If you meant the crop coefficient, the sections above apply.

How much can I realistically cut irrigation after applying compost?

With a 5 cm surface mulch in a hot, dry, windy site, extending the interval between irrigations by roughly 20–40% during the first weeks after application is a reasonable starting hypothesis — but verify it with the paired-plot test before you change a whole block. In humid or cool conditions the saving is often much smaller.

If you are specifying compost for a commercial block, send us the grade (feedstock, maturity, EC, organic matter content), target application rate and depth, crop, soil texture and climate zone, and we will help you work out whether a Kc adjustment or an interval adjustment is the more sensible route for your site.

Related reading

Related reading

By

Leave a Reply

Your email address will not be published. Required fields are marked *