What compost tea is and what it can realistically do
Compost tea is compost steeped in water — usually aerated and fed a sugar source such as molasses — then diluted and applied to soil, roots or leaves. It works mainly as a microbial inoculant and as a way to spread a small volume of good compost over a large area, not as a fertiliser substitute: typical brews carry well under 1% nitrogen, and normal application rates deliver only single-digit kilograms of nutrients per hectare. Expect measurable shifts in soil and leaf-surface biology, and modest, inconsistent effects on yield.

How it actually works
Two processes run inside a brewer, and they work on different clocks. The first is extraction: agitation and time pull soluble humic compounds, salts and microbes off the compost particles and into suspension. The second is incubation: bacteria consume the added sugar and multiply, then protozoa and nematodes graze them and release plant-available nitrogen as a by-product. Extraction is largely physical and mostly finished within a few hours. Incubation is biological and depends on temperature, food and — above all — oxygen.
Dissolved oxygen decides which community you grow. Aerobic organisms dominate above roughly 6 mg/L; between 4 and 6 mg/L the brew is stressed; below about 2–3 mg/L anaerobes take over and produce organic acids, alcohols and sulfides that can damage roots and leaf tissue. A 100 L brewer typically needs 6–10 L/min of air to hold that line, and more in warm weather. At 20–25°C a batch peaks somewhere around 24–36 hours; leave it longer and the sugar is spent, oxygen sags and the population drifts toward something you did not intend to spray.
One point is worth stating plainly: the tea cannot be better than the compost. Brewing multiplies what is already present and dissolves what is soluble. It does not create organisms that were absent, and no aeration schedule rescues compost that was immature, salty or contaminated.
What the numbers mean
Most published recipes are variations on the same few ratios. For reference, a standard aerated batch uses 1 part compost to 5–10 parts water by weight — 10–20 kg of compost in 100 L — held in a mesh bag of roughly 400–500 microns. Molasses goes in at 0.5–1% by volume, so 0.5–1 L per 100 L; rates up to 2% push the brew more bacterial but also crash oxygen faster. Finished tea is commonly diluted 1:5 to 1:10 for a soil drench and around 1:10 for foliar work, though many growers apply it undiluted within a few hours of brewing.
Application volume matters more than most labels suggest. A soil drench of 200–500 L/ha of diluted tea wets the root zone of a row crop; foliar passes are usually 100–200 L/ha and only need to wet the leaf surface, not run off. At garden scale, 1–2 L per plant or per square metre is a reasonable starting point. Nutrient content is genuinely low — total nitrogen in a finished brew commonly falls in the 0.05–0.5% range, so a 1:10 drench supplies only a few kilograms of N per hectare.
Water quality quietly sets the ceiling. Municipal supplies often carry 0.5–1 mg/L residual chlorine, enough to knock back a fresh brew; letting a tank stand uncovered for 24 hours or passing it through a carbon filter removes most of it. Aim for a brew pH between 5.5 and 7.5 and resist adjusting it, because buffers and acids often harm the organisms more than the original pH did.
| Option | Typical prep time | Oxygen need | Microbial load | Best suited to | Main risk |
|---|---|---|---|---|---|
| Aerated compost tea | 24–36 h at 20–25°C | High — hold ≥6 mg/L | Highest of the water-based options | Soil drenches, foliar programmes | Oxygen crash if sugar or temperature runs high |
| Non-aerated steep | 3–7 days, stirred daily | None | Variable, often more anaerobic | Rough ground, compost activation | Foul odour, organic acids, root damage |
| Compost extract | 1–2 h agitation, no incubation | Low | Reflects the compost, little growth | Quick inoculum before planting | Settles out fast, very short shelf life |
| Granular compost | None | None | High, slow release | Beds, orchards, long-term build | Volume and haulage cost |
| Soluble fertiliser | Minutes | None | None | Correcting a measured deficiency | No biological contribution, salt load |
How to choose or apply it
Decide the job first. If the target is soil biology in a tired bed, a drench every 2–4 weeks through the growing season is the usual pattern. If the target is leaf-surface competition against foliar pathogens, smaller and more frequent passes every 10–14 days tend to serve better than one heavy soak. Neither is a rescue treatment for a nutrient deficiency, and neither replaces a considered fertiliser programme.
- Source mature compost: 3–6 months old, earthy smell, no ammonia, no visible mould.
- Fill the brewer three-quarters with dechlorinated water at 18–25°C.
- Load 10–20 kg compost per 100 L into a 400–500 micron bag and suspend it rather than letting it sit on the bottom.
- Add 0.5–1 L molasses per 100 L, dissolved in warm water first.
- Aerate at 6–10 L/min per 100 L and watch the meter rather than the clock.
- Run 24–36 hours, checking dissolved oxygen, pH and smell at 12 and 24 hours.
- Apply within 4–8 hours of switching the air off; dilute to the crop and method.
- Spray early morning or late afternoon, and dampen dry soil lightly beforehand so the biology has somewhere to land — the same logic that governs any irrigation and soil management decision.
Before the sprayer leaves the shed, run this check:
- Compost smells earthy, not sour or ammonia-like.
- Dissolved oxygen still above 6 mg/L at the end of the brew.
- No chlorine residual in the mix water.
- Tank, lines and nozzles free of sanitiser residue.
- Inline filter of 200 mesh or finer if the tea goes through drip lines.
- Not tank-mixed with copper, sulfur or oxidising sanitisers.
- On edible crops, stop manure-based brews 90–120 days before harvest where your certification scheme requires it.
Common mistakes
The most frequent failure is over-feeding. Doubling the molasses does not double the biology; it feeds a bacterial bloom that strips oxygen within hours, and the batch turns sour. If the brew foams heavily and smells like a pond, the air supply is losing the race.
Brewing too long is the second. A 72-hour batch in a warm shed is usually a different product from the one you planned. So is a sealed bucket: without air exchange, even a good brew goes anaerobic within a couple of hours of the pump stopping, which is why the working window is measured in hours rather than days.
Then there is timing and mixing. Ultraviolet light and midday heat reduce viability on the leaf surface, and chlorine or sanitiser residue in a sprayer undoes an entire batch. Treating compost tea as a fertiliser is the last and most expensive mistake — it will not correct a nitrogen or potassium shortfall, and the crops that respond best are usually the ones already on a sound nutrition and water programme.
Does compost tea replace fertiliser?
Generally no. Nutrient concentrations are low and variable, so it complements a balanced fertiliser plan rather than substituting for it. Use soil or tissue tests to decide nutrient rates and treat the tea as a biological input alongside them.
Can I make it without an air pump?
You can make a non-aerated steep, but it is a different product with a higher risk of anaerobic conditions and foul smells. Small home garden batches of 20–40 L with a modest aquarium pump and 1–2 kg of compost are usually more predictable than large still tanks.
How often should I apply it?
For soil drenches, every 2–4 weeks during active growth is a common interval; for foliar work, every 10–14 days while disease pressure lasts. Frequency matters more than volume, and applications just before or after rain are largely wasted.
Practical note: if you are building a brew or soil-input programme and need compatible polymer, coating or garden-line products quoted alongside it, send your target rates, water hardness and crop list and we will price against those specifications.